Repairs & Maintenance

  • Home
  • /
  • Repairs & Maintenance

Enquire About Your Warranty

Not sure about the details of your warranty? Fill in a quick form and find out everything you need to know.

Enquire

Register Your Gap Geyser

Register your GAP Geyser to activate the warrenty on the product but taking a minute to fill in a form.

Register

Gap Holdings Emergency Number

For any geyser emergencies
please contact us at

Office Hours: 011 392 3059
After Hours: 072 725 0135

GAP Holdings Maintenance & Repairs

Anode:

It is highly recommended that the Anode in your geyser is replaced at least every two years. The Anode assists in the protection of your geyser and thus changing it every two years will extend the life expectancy of your geyser, particularly in areas with high chlorides in the water.

Drip Tray:

  • Ensure that a Drip Tray is installed with your geyser, and that the Drip Tray is the correct size for your specific geyser… i.e. – 100L geyser = 100L drip Tray, 150L geyser = 150L drip Tray… etc.
  • Ensure that the outlet of the Drip Tray isn’t blocked in any way, i.e. – no leaves, papers, soil, excessive dust or spider webs… etc.
  • Ensure that the Drainage Pipe from the Drip Tray is correctly fitted and that it extends far enough to the outside of the house, so as not to cause damage to the roof or walls (rust marks on the walls, etc).
  • Ensure that the Drip Tray and Drainage Pipe have no leaks that might cause damage to the ceiling.

Overflow Pipe:

  • Ensure that an Overflow Pipe is connected to the geyser and that the Overflow Pipe extends far enough to the outside of your house, to prevent damage to the roof and walls (rust marks on the walls… etc.)
  • Ensure that the Overflow Pipe has no leaks that might cause damage to the ceiling.

Valves and Fittings:

  • Ensure that all Valves and Fittings are correctly attached to the geyser, i.e. – PRV, Safety Valve, Drain Cock, Vacuum Breaker, etc.
  • Ensure that the Valves and Fittings attached to the geyser comply with the working pressure of the geyser, e.g:400Kpa.
  • Ensure that none of the Valves and Fittings are blocked and are in proper working order, as this will ensure that your geyser operates at the optimal performance it has been designed for.

Thermostat:

Ensure that the geyser Thermostat is set at approximately 55 °C as this is the optimal working temperature that the geyser has been designed for and it will also extend the life expectancy of your geyser.


**** YOUR FRIENDLY LOCAL QUALIFIED PLUMBER WILL BE ABLE TO ASSIST YOU WITH ANY OF THE ABOVE ****